AKD7600-A Datasheet, PDF (8/45 Pages) Asahi Kasei Microsystems – AK7600VF Evaluation Board Rev.1

[AKD7600-A]
Control Software Manual
„ Set-up of the evaluation board and control software
1. Setup the AKD7600-A board according to previous.
2. Connect AKD7600-A to PC with the cable packed. Push down the reset button ‘SW1’ to initialize the USB chip.

(According to following explanation “USB connection”)
3. Insert the CD-ROM labeled “AKD7600-A Evaluation Kit” into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of “AK7600.exe” to set up the program.
(AK7600.exe: This is the control software for AK7600VF.)
5. Then, please evaluate according to “Control software operation flow”.
„ USB connection
1. Insert the USB cable to the USB port on AKD7600-A board. If there is an error message, device has not been
recognized from the windows, click the message and cancel it.
2. Press the button which is ‘SW1’ on the board, and the windows O.S. will recognize this board automatically.
3. It can be verified to be connected on ‘Human Interface Device (HID)’ of the device manager on the windows.
*Please use a set of a board and software one to one. It is recommended not to use multiple connections.
„ Control software operation flow
Keep the following flow
1. Activate the software as double-click ‘AK7600.exe’.
2. Click ‘Board Init’ button to initialize the board.
3. Select the needed dialogue to evaluate by changing the setting.
(Note) If the USB cable is removed when the control software is being used, please close the software and start this
operation flow again from first.
< KM091700>
-8-
2008/04