|
AKD4588 Datasheet, PDF (8/46 Pages) Asahi Kasei Microsystems – Evaluation board Rev.C for AK4588 | |||
|
◁ |
ASAHI KASEI
[AKD4588]
AKD4588 (DIR/DIT) part Control Program operation manual
 Set-up of evaluation board and control software
1. Set up the AKD4588 (DIR/DIT) according to previous term.
2. Connect IBM-AT compatible PC with AKD4588 by 10-line type flat cable (packed with AKD4588). Take care of
the direction of 10pin header. (Please install the driver in the floppy-disk when this control software is used on
Windows 2000/XP. Please refer âInstallation Manual of Control Software Driver by AKM device control softwareâ.
In case of Windows95/98/ME, this installation is not needed. This control software does not operate on Windows
NT.)
3. Insert the CD-ROM labeled âAK4588 Evaluation Kitâ into the CD-ROM drive.
4. Access the CD-ROM drive and double-click the icon of âAKD4588 (DIR/DIT)-1.exeâ (address 00H-0FH) to set up
the control program.
5. Then please evaluate according to the follows.
 Operation flow
Keep the following flow.
1. Set up the control program according to explanation above.
2. Then set up the dialog and input data.
 Explanation of each buttons
1. [Port Setup]: set up the printer port.
2. [Write default]: initialize the register of AK4588.
3. [All read]:
read all registers.
4. [Read]:
read data from each register.
5. [Write]:
write data to each register.
If you want to write the input data to AK4588, click âOKâ button. If not, click âCancelâ button.
 Indication of data
Input data is indicated on the register map. Red letter indicates âHâ or â1â and blue one indicates âLâ or â0â. Blank is the
part that is not defined in the datasheet.
<KM073800>
-8-
2004/02
|
▷ |