AKD4710-A Datasheet, PDF (7/30 Pages) Asahi Kasei Microsystems – AK4710 Evaluation Board Rev.1

ASAHI KASEI
[AKD4710-A]
1-1. [Write]: Data Writing Dialog
It is for when changing two or more bits on the same address at the same time.
Click [Write] button located on the right of the each corresponded address for a pop-up dialog box.
When the checkbox is checked, the data will be “H” or “1”. When the checkbox is not checked, the data will be “L”
or “0”. Click [OK] to write setting values to the registers, or click [Cancel] to cancel this setting.
Figure 3. Window of [ Register Set ]
1-2. [Read]: Data Read
Click [Read] button located on the right of the each corresponded address to execute a register read.
After register reading, the display will be updated regarding to the register status.
Button Down indicates “H” or “1” and the bit name is in red (when read only it is in deep red).
Button Up indicates “L” or “0” and the bit name is in blue (when read only it is in gray)
Please be aware that button statuses will be changed by a Read command.
<KM105902>
-7-
2011/06