AKD5388-A Datasheet, PDF (4/36 Pages) Asahi Kasei Microsystems – AK5388 Evaluation Board Rev.4

[AKD5388-A]
Default configuration of switch and jumper pins
SW1-1
SW1-2
SW1-3
SW1-4
SW1-5
SW1-6
SW1-7
SW1-8
Name
M_SN
CKS2
CKS1
CKS0
TDM1
TDM0
MONO
HPFE
Setting
Name
OFF
SW2-1
DIF
ON
SW2-2
CKS1
OFF
SW2-3
CKS0
OFF
OFF
OFF
OFF
OFF
Table 2. Switch setting
Setting
OFF
ON
ON
Name
Setting
Name
Setting
JP1
TEST1
Short
JP11
MCLK
XTL
JP21
JP2
TEST2
Short
JP12
CLK
X/2
JP22
JP3
TEST3
Short
JP13
BCFS
X2/4
JP23
JP4
BICK
Short
JP14
LRFS
X2/256
JP24
JP5
LRCK
Short
JP15
GND
Open
JP25
JP6
TDMIN
GND
JP16
XTE
Open
JP7
D-SEL1 SDTO1
JP17
EXT
Short
JP8
D-SEL2 SDTO1
JP18 LIN1-BNC Short
JP9
AVDD
REG
JP19 LIN1-BNC Short
JP10
DVDD
REG
JP20 RIN1-BNC Short
Table 3. Jumper pins setting
Name
RIN1-BNC
LIN2-BNC
LIN2-BNC
RIN2-BNC
RIN2-BNC
Setting
Short
Short
Short
Short
Short
Other jumper pins set up
1. JP6 (TDMIN) : Input data selection to TDMIN
EXT : Select data of SDTO1 of PORT3(DSP1) or PORT4(DSP2) is input.
In this case, either JP7 or JP8 is set to TDMIN. Separated.
GND : 0V is input. <Default>
2. JP7 (D-SEL1) : Selection to SDTO1 of PORT3
SDTO1 : Connects with SDTO1 of AK5388. <Default>
TDMIN : Connects with TDMIN of AK5388.
3. JP8 (D-SEL2) : Selection to SDTO1 of PORT4
SDTO1 : Connects with SDTO1 of AK5388. <Default>
TDMIN : Connects with TDMIN of AK5388.
4. JP9 (AVDD) : Select AVDD for AK5388
+5V : Supply from +5V connector.
REG : Supply from regulator T1. In this case, +5V connector should be open. <Default>
5. JP10 (DVDD): Select DVDD for AK5388
+3.3V : Supply from +3.3V connector.
REG : Supply from regulator T2. In this case, +3.3V connector should be open. <Default>
<KM090205>
-4-
2009/03