AKD4384-SC Datasheet, PDF (3/32 Pages) Asahi Kasei Microsystems – 192kHz sampling 24Bit ΔΣ DAC

[AKD4384-SC]
Evaluation mode
1. DIR (COAX) (default)
It is possible to evaluate the AK4384 by using CD disk. The DIR generates MCLK, BICK, LRCK and SDATA from the
received data through BNC connector (J1). Setting of jumper is shown below.
COAX is recommended for an evaluation of the Sound quality.
JP1
OPT
COAX
BNC
(Default)
Figure 2. Jumper setting, when using DIR
2. DIR (Optical Link)
It is possible to evaluate the AK4384 by using CD disk. The DIR generates MCLK, BICK, LRCK and SDATA from the received
data through optical connector (PORT3: TORX176). Setting of jumper is shown below.
JP1
OPT
COAX
PORT3
Figure 3. Jumper setting, when using DIR
3. All clocks are fed through the PORT1.
R13, R15, R17, R18 : open
R1, R2, R3, R8
: 100Ω or short (0Ω)
DIP Switch setting
[SW2]: AK4113 setting
No.
Pin
1
OCKS1
2
OCKS0
OFF
ON
AK4113 Master Clock setting
Refer to Table4
Table 2. SW2 setting
[S1]: AK4384 setting
No.
Pin
1
SMUTE
2
P/S
3
ACKS
4
-
OFF
ON
Soft Mute Pin in parallel
mode : “Disable”
Soft Mute Pin in parallel
mode : “Enable”
Parallel Control mode
Manual setting mode
NC
Serial Control mode
Auto setting mode
Table 3. SW3 setting
Default
ON
OFF
Default
OFF
OFF
ON
OFF
<KM079003>
3
2007/06