|
AKD4364 Datasheet, PDF (22/30 Pages) Asahi Kasei Microsystems – EVALUATION BOARD REV.A FOR AK4364 | |||
|
◁ |
ASAHI KASEI
[AKD4364 Control Program]
AKD4364 Control Program ver 2.0 operation manual
1. Connect IBM-AT compatible PC with AKD4364 by 10-line type flat cable (packed with AKD4364).
Take care of the direction of 10pin Header (Refer to manual of AKD4364).
2. Start up âWINDOWS 95â or âWINDOWS 98â.
3. Insert the floppy-disk labeled âAKD4364 Control Program ver 2.0â into the floppy-disk drive.
4. Set up âMS-DOSâ from start menu.
5. Change directory to the floppy-disk drive(ex.a:) at MS-DOS prompt.
6. Type âak4364â.
7. Then follow the displayed comment (See the following).
==================== <<Operating flow>> =====================
Input Control Mode (3-wire serial or I2C bus)
Input Chip Address (2bit)
Write data/ Display register map/ Reset etc.Ã loop
=========================================================
â00/4
-1-
|
▷ |