AK4104_10 Datasheet, PDF (14/21 Pages) Asahi Kasei Microsystems – 192kHz 24-Bit 3.3V DIT

[AK4104]
■ μP Control Interface
The AK4104 can select 4-wire μP I/F mode (MODE bit = “0”) or 3-wire μP I/F mode (MODE bit = “1”).
1.4-wire Serial mode (MODE bit = “0”, default)
The internal registers may be either written or read by the 4-wire μP interface pins: CSN, CCLK, CDTI and CDTO. The
data on this interface consists of Chip address (2bits, C1/0; fixed to “11”), Read/Write (1bit), Register address (MSB first,
5bits) and Control data (MSB first, 8bits). Address and data are clocked in on the rising edge of CCLK and data is clocked
out on the falling edge. For write operations, data is latched after the 16th rising edge of CCLK, after a high-to-low
transition of CSN. CSN should be set to “H” once after the 16th CCLK. For read operations, the CDTO output goes high
impedance after a low-to-high transition of CSN. The maximum speed of CCLK is 5MHz. PDN pin = “L” resets the
registers to their default values.
CSN
CCLK
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
WRITE
CDTI
CDTO
READ
CDTI
CDTO
C1 C0 R/W A4 A3 A2 A1 A0 D7 D6 D5 D4 D3 D2 D1 D0
Hi-Z
C1 C0 R/W A4 A3 A2 A1 A0 D7 D6 D5 D4 D3 D2 D1 D0
Hi-Z
Hi-Z
D7 D6 D5 D4 D3 D2 D1 D0
C1-C0: Chip Address: (Fixed to “11”)
R/W: READ/WRITE (0:READ, 1:WRITE)
A4-A0: Register Address
D7-D0: Control Data
Figure 17. 4-wire μP I/F Timing
*When the AK4104 is in the power down mode (PDN pin = “L”) or the MCLK is not provided, writing into the control
register is inhibited.
MS0642-E-01
- 14 -
2010/09