AKD5702-A Datasheet, PDF (11/33 Pages) Asahi Kasei Microsystems – portable digital audio 16bit A/D converter

ASAHI KASEI
[AKD5702-A]
„ Other jumper pins set up
1. JP1, JP3 (MPWRB): Connect to MPWRB
OPEN
: No connect <Default>
SHORT
: Connect to MPWRB
2. JP2, JP4 (MPWRA) : Connect to MPWRA
OPEN
: No connect <Default>
SHORT
: Connect to MPWRA
3. JP17 (LIN125_SEL)
LIN1
LIN2
LIN5
: Select input pin from J4
: Enable to input to LIN1 from J4 <Default>
: Enable to input to LIN2 from J4
: Enable to input to LIN5 from J4
4. JP18 (RIN125_SEL)
RIN1
RIN2
RIN5
: Select input pin from J6
: Enable to input to RIN1 from J6 <Default>
: Enable to input to RIN2 from J6
: Enable to input to RIN5 from J6
5. JP19 (LIN5_SEL)
LIN125
LIN345
: Select input connecter to LIN5
: Enable to input to LIN5 from J4 <Default>
: Enable to input to LIN5 from J7
6. JP20 (RIN5_SEL)
RIN125
RIN345
: Select input connecter to RIN5
: Enable to input to RIN5 from J6 <Default>
: Enable to input to RIN5 from J9
7. JP21 (LIN345_SEL)
LIN3
LIN4
LIN5
: Select input pin from J7
: Enable to input to LIN3 from J7 <Default>
: Enable to input to LIN4 from J7
: Enable to input to LIN5 from J7
8. JP22 (RIN345_SEL)
RIN3
RIN4
RIN5
: Select input pin from J9
: Enable to input to RIN3 from J9 <Default>
: Enable to input to RIN4 from J9
: Enable to input to RIN5 from J9
9. JP35 (SDTOB_SEL) : Select input pin to TDMIN
PDOWN
: Connect to GND <Default>
SDTOB
: Connect to SDTOB
10. JP36 (CTRL_SEL) : Select for µp Control Mode
3-WIRE : Select to 3-WIRE <Default>
I2C
: Select to I2C
11. JP37 (GND)
OPEN
SHORT
: Analog ground and Digital ground
: Separated. <Default>
: Common. (The connector “DGND” should be open.)
12. JP38 (AVDD_SEL) : AVDD of the AK5702
REG
: AVDD is supplied from the regulator (“AVDD” jack should be open). < Default >
AVDD
: AVDD is supplied from “AVDD ” jack.
<KM086501>
- 11 -
2007 / 04