AKD4687-A Datasheet, PDF (10/52 Pages) Asahi Kasei Microsystems – Evaluation board Rev.2 for AK4687

[AKD4687-A]
Control Soft Manual
■ Evaluation Board and Control Soft Settings
1. Set an evaluation board properly.
2. Connect the evaluation board to an IBM PC/AT compatible PC by a 10 wire flat cable. Be care of the direction of the
10pin header. Before running this control soft on Windows 2000/XP, the driver included in the CD must be installed.
Refer to the “Driver Control Install Manual for AKM Device Control Software” for installation of the driver. When
running this control soft on Windows 95/98/ME or via an AKDUSBIF-B interface board, driver installing is not
necessary.
3. Continue to evaluate by following steps.
■ Operation Screen
1. Start up the control program, and the operation screen is shown below.
<KM104603>
- 10 -
2011/06