UG-515 Datasheet, PDF (8/28 Pages) Analog Devices – Full-featured evaluation board

EVAL-ADAS3023EDZ
EVALUATION BOARD SOFTWARE
SOFTWARE INSTALLATION
It is recommended that you close major Windows applications
prior to installing the software.
System Requirements
• PC operating Windows XP or Vista
• USB 2.0 (for CED board)
• Administrator privileges
Website Download
The software versions are also available from the Analog
Devices PulSAR Analog to Digital Converter Evaluation Kit
page. After downloading the software, it is recommended to
use the WinZip Extract function to extract all of the necessary
components as opposed to just clicking on setup.exe in the
zipped file.
After extracting, click on setup.exe in the folder created during
the extraction and follow the instructions on the screen. If
another version exists, it may be necessary to remove it.
USB Drivers
The software also installs the necessary USB drivers. After
installing the software, power up the CED board and connect
to the PC USB 2.0 port. The Windows Found New Hardware
Wizard will display.
Click Next to install the drivers automatically.
Evaluation Board User Guide
When installed properly, Windows displays a completion
message as shown in Figure 5.
Figure 5. Completing the Found New Hardware Wizard
On some PCs, the Found New Hardware Wizard may show up
again and, if so, follow the same procedure to install it properly.
The Device Manager can be used to verify that the driver was
installed successfully.
Figure 6. Device Manager
Figure 4. Welcome to the Found New Hardware Wizard
Rev. A | Page 8 of 28