EVAL-ADM1023 Datasheet, PDF (8/12 Pages) Analog Devices – Evaluation Board for Microprocessor System Temperature Monitor

EVAL-ADM1023
Preliminary Technical Data
ONE-SHOT OPERATION
When the ADM1023 is put into standby mode by setting bit 6 of
the Configuration register or clicking on the
button, a one-shot reading of the
remote temperature may be taken by clicking on the
will then be displayed.
button. The temperature found
ALERT INDICATION
When the Control Center tab is first selected, the Alert Status
Indicator
is off.
If Alert detection is turned on by clicking on the
button. The legend will change to
CONTROL CENTER
The Control Center tab allows readings to be displayed
graphically on bargraphs or line graphs.
and the
indicator
will become active. It will change from green to red
BAR GRAPHS
At the bottom of the Control Center tab are bargraphs for the
Y _{local and remote sensors. These can be toggled on and off by}
AR _{clicking on the}
button. The legend will
IN _{L change to}
and clicking again will turn off
IM ^A the bargraphs. The high and low temperature limits can be
EL ^{IC changed by moving the pointer arrows below the bargraphs.}
R ^{N The ADC sampling rate can be changed by rotating the control}
knob next to the bargraphs.
when the local or remote temperature
goes outside limits, and the ALERT LED (D2) on the evaluation
board will light. The LED can be turned off by clicking on the
button, provided the temperature has
gone back within limits, or the limits have been adjusted to be
outside the temperature reading. The Alert Status Indicator
automatically changes back to green when the temperature is
within limits. Alert detection can be turned off again by clicking
on
.
P _{TECHDATA Figure 6. Read/Write Program Tab}
–8–
REV. A