EVAL-ADM1023 Datasheet, PDF (6/12 Pages) Analog Devices – Evaluation Board for Microprocessor System Temperature Monitor

EVAL-ADM1023
Preliminary Technical Data
The software will search for the ADM1023 and when it is
found the following screen will appear. The device address
given will depend on the settings of J7 and J8
Click on “Next” to go to the next screen, which allows
Y _{the user to select between connecting the evaluation board}
R _{via the printer port or via the SMBus. The PIIX4 SMBus}
A Interface is intended for when the ADM1023 is present on
the PC’s motherboard. While using the evaluation board
PRTEELCIMHDINNAITCAAL ^{the Parallel Printer Port Option should always be selected.}
If this is the device the user intends to use, click on “Yes”
and the following screen appears. If the user wants to use a
different device click on “No” to continue searching.
Once the communication medium has been selected, click
on “Next” to go to the next screen. When you are ready
for the software to begin searching for the evaluation
board on either the parallel port or the SMBus , click
“Next”
If the device was not found the following screen will
appear. In this case check the connections to the
evaluation board, click on “Back” and try again. If this
does not work then try re-booting the PC and re-running
the software
–6–
REV. A