UG-1071 Datasheet, PDF (4/6 Pages) Analog Devices – Access to all analog and digital pins

UG-1071
ADuCM362/ADuCM363 Getting Started Guide
IAR EMBEDDED WORKBENCH
The IAR Embedded Workbench integrates all the tools
necessary to edit, assemble, and debug code. The fastest way to
get started is to open an existing workspace by following these
steps:
1. Open the IAR tools from the Start Menu.
2. Within the IAR IDE, click File > Open > Workspace and
open a workspace provided by Analog Devices (for example,
C:\ADuCM36x…\code\ADuCM362\examples\Blink\DI
O.eww).
3. Compile and download the code to the device using
Project > Rebuild All and then Project > Download
Active Application.
4. Click No if a pop-up window appears identifying an
unknown device.
5. To run the code, press RESET on the evaluation board or
enter debug mode by clicking the Download and Debug
button (see Figure 6) and then click Go (see Figure 7).
3. Details for installation of the drivers appear on the screen
the first time the user plugs the evaluation board into the
PC or if using a different USB port. Allow the installation
of these drivers to complete as they provide a virtual
communication port on the PC that allows the evaluation
board to appear as a virtual serial communication port to the
UART port of the ADuCM362/ADuCM363 device.
4. If using the virtual serial communication port to the UART,
ensure Jumpers LK3 and LK5 are in place on the evaluation
board (see Figure 9).
5. Plug the 10-pin DIL connector of the J-Link OB emulator
into the EVAL-ADuCM362QSPZ or EVAL-
ADuCM363QSPZ
6. The evaluation board is powered by computer from the the
USB cable connected to the J-Link OB emulator. The green
POWER LED turns on.
Figure 6. Download and Debug Button
Figure 7. Go Button
6. When running, the red LED marked DISPLAY on the
evaluation board flashes.
ELVES.EXE
Elves.exe is an application that chooses functions from the
provided function sets and function parameters. Elves.exe can
be integrated into the Keil μVision5 and IAR tools under the
tool menus. For instructions, run Elves.exe (for example, at
C:\ADuCM36x…\Software Tools\Elves\Elves.exe) and press the
F1 key or click the Help button.
EVALUATION BOARD SETUP PROCEDURES
Assembling and Connecting the Hardware
Do not plug in the USB cable before the software is installed.
Use the following steps to connect the hardware:
1. Insert the USB cable provided between the PC and the J-Link
OB emulator (emulator shown in Figure 8).
2. The red LED (LED1) flashes until initialization of the drivers
completes.
Figure 8. Emulator, Top View
Figure 9. J-Link OB Connection Details
Rev. 0 | Page 4 of 6