ADSP-SC589 Datasheet, PDF (16/64 Pages) –

2.4 EZ-Board Installation
It is assumed that the CrossCore Embedded Studio software is installed and running on your PC.
Follow these instructions to ensure correct operation of the product software and hardware.
Step 1: Connect an emulator to the EZ-Board.
Plug one side of the included USB cable into the USB connector of the emulator. Plug the
other side into a USB port of the PC.
The status LED (labeled STATUS) lights up green if the connection with the PC is working
and the appropriate Windows driver is installed. Please refer to the appropriate emulator
manual if the status LED does not turn on.
Attach the emulator header (J2) on the bottom of the ICE-1000 to the P3 connector on the EZ-
Board.
Step 2: Attach the provided cord and appropriate plug to the 5V power adaptor.
Plug the jack-end of the assembled power adaptor into the power connector P22 (labeled 5V)
on the EZ-Board.
Plug the other side of the power adaptor into a power outlet. The power LED LED9 (labeled
POWER) lights green when power is applied to the board.
2.5 EZ-Board Session Startup
It is assumed that the CrossCore Embedded Studio software is installed and running on your PC.
Note: If you connect the board or emulator first (before installing CCES) to the PC, the
Windows driver wizard may not find the board drivers.
ADSP-SC589 EZ-Board® Evaluation System Manual
16