HMC546LP2E Datasheet, PDF (12/13 Pages) Analog Devices – 10 W, Failsafe, GaAs, SPDT Switch 0.2 GHz to 2.7 GHz

HMC546LP2E
EVALUATION PCB
When using the circuit board in an application, generate proper
RF circuit design techniques. Ensure that signal lines have 50 Ω
impedance and that the package ground leads and exposed
paddle are connected directly to the ground plane, as shown in
Figure 26. The evaluation circuit board shown in Figure 26 is
available from Analog Devices, Inc., upon request.
Data Sheet
Bill of Materials
Table 6. Bill of Materials¹
Item²
Description
J1 to J3
PCB mount SMA RF connector
J4 to J6
DC pins
C1 to C3
Capacitors, 0402 package
L1, L2
Inductors
U1
HMC546LP2E transmit/receive switches
PCB³
110780 evaluation PCB
1 _{When requesting an evaluation board, reference the appropriate evaluation}
PCB number listed in the Ordering Guide section.
2 _{Refer to Table 5 for component values.}
3 _{Circuit board material: Rogers 4350.}
Figure 26. Evaluation Printed Circuit Board (PCB)
Rev. E | Page 12 of 13