CN0385 Datasheet, PDF (12/13 Pages) Analog Devices – Devices Connected

CN-0385
First, connect a 5 V to 12 V dc wall wart to the P3 dc jack or to
Terminal Block J1 and Jumper J2 on position V_EXT. Or, place
J2 in position V_FMC to use the 12 V supply from the SDP-H1
board. Then connect the SDP-H1 board to the PC via the USB
to micro-USB cable.
Test
With the power supply or dc wall wart and USB cable connected,
launch the evaluation software. When USB communications are
Circuit Note
established, the SDP-H1 board can be used to send, receive, and
capture data from the EVAL-CN0385-FMCZ board and perform
data analysis in the time and frequency domains.
Information and details regarding test setup and calibration,
and how to use the evaluation software for data capture can be
found in the CN-0385 Software User Guide (available at
www.analog.com/CN0385-UserGuide).
Figure 27. EVAL-CN0385-FMCZ Evaluation Hardware
Rev. 0 | Page 12 of 13