UG-400 Datasheet, PDF (1/20 Pages) Analog Devices – Plug and play system evaluation

Hardware User Guide
UG-400
One Technology Way • P.O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: [phone] • Fax: [phone] • www.analog.com
ezLINX iCoupler Isolated Interface Development Environment
FEATURES
Plug and play system evaluation
Easy evaluation of 8 isolated physical layer communication
standards
Open source hardware
Open source software
iCoupler and isoPower technology
ADSP-BF548 Blackfin processor running uClinux
Sample PC application
Sample embedded uClinux application
64 MB RAM
32 MB flash
Extender connector for additional functionality
APPLICATIONS
Isolated interfaces
EVALUATION KIT CONTENTS
EZLINX-IIIDE-EBZ
Power supply
ezLINX software DVD
USB A to mini USB B cable
GENERAL DESCRIPTION
The ezLINX™ iCoupler® isolated interface development
environment provides developers with a cost-effective, plug
and play method for evaluating eight digitally isolated physical
layer communication standards (USB, RS-422, RS-485, RS-232,
CAN, SPI, I²C, and LVDS). The Blackfin® ADSP-BF548 processor
runs the uClinux® operating system and allows for easy customi-
zation through the open source hardware and software platform.
Development time is significantly reduced for embedded designers
and system architects who are designing and evaluating isolated
communication standards. The interfaces on ezLINX use Analog
Devices, Inc., isolated transceivers with integrated iCoupler and
isoPower® digital isolator technology.
The hardware of the ezLINX iCoupler isolated interface develop-
ment environment contains the ADSP-BF548 Blackfin processor
with 64 MB of RAM and 32 MB of flash memory. The isolated
physical layer communication standards are implemented using
Analog Devices isolated transceivers with integrated iCoupler and
isoPower technology. Devices used to implement these isolated
physical layer communication standards include the following:
• Isolated USB using the ADuM3160
EZLINX-IIIDE-EBZ
Figure 1.
• Isolated CAN using the ADM3053 signal and power
isolated CAN transceiver
• Isolated RS-485 and RS-422 using the ADM2587E signal
and power isolated RS-485/RS-422 transceiver
• Isolated RS-232 using the ADM3252E signal and power
isolated RS-232 transceiver
• Isolated I²C using the ADuM1250 and ADuM5000
• Isolated SPI using the ADuM3401, ADuM3402, and
ADuM5000
• Isolated LVDS using the ADuM3442, ADuM5000,
ADN4663, and ADN4664
This evaluation board contains multiple parts with isoPower
technology, which uses high frequency switching elements to
transfer power through the transformer. Special care must be
taken during PCB layout to meet emissions standards. See the
AN-0971 Application Note, Recommendations for Control of
Radiated Emissions with isoPower Devices, for board layout
recommendations. The ezLINX PCB layout has not been verified
to pass radiated emissions specifications.
PLEASE SEE THE LAST PAGE FOR AN IMPORTANT
WARNING AND LEGAL TERMS AND CONDITIONS.
Rev. 0 | Page 1 of 20