Z16C01 Datasheet, PDF (4/14 Pages) Zilog, Inc. – CPU CENTRAL PROCESSING UNIT

ABSOLUTE MAXIMUM RATINGS
Z16COlKO2 +
cPs95scc0103
Voltages on V,, with respect to V,, ..............-0.3V to +7.OV
Voltages on all inputs with respect to
Vss........““............................................. -0.3V to V,,+O.3V
Storage Temperature.. ...............................-65”C to + 150%
Stresses greater than those listed under Absolute Maxi-
mum Ratings may cause permanent damage to the de-
vice. This is a stress rating only; operating of the device at
any condition above these indicated in the operational
sectionsof these specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods
may affect device reliability.
STANDARD TEST CONDITIONS
The DC characteristics below apply for the following test
conditions, unless otherwise noted. All voltages are refer-
enced to GND (OV). Positive current flows into the refer-
enced pin.
Available operating temperature ranges are:
s = 0°C to +7O”C, + 4.5v s V,,I + 5.5v
(Z16COi,Zl6CO2)
E = -4OOC to +lOO”C, + 4.5V IV& + 5.5V
(Z16CO1, Zi 6CO2)
All AC parameters assume a total load capacitance
(including parasitic capacitances) or 100 pf max, except
for parameter 6 (50 pf max). Timing reference between two
output signals assume a load difference of 50 pf max.
The Ordering Information section lists package tempera-
ture ranges and product numbers.
DC CHARACTERISTICS
SYm ^Parameter
V_CH
ClockinputHighVoltage
V_CL
ClockinputLowVoltage
VI,
InputHighVoltage
V,, RESET InputHighVoltageon/RESETPin
V,,NMI InputHighVoltageon NMIPin
Vi,
InputLowVoltage
V_OH
OutputHighVoltage
V_OL
OutputLowVoltage
I
InputLeakage
I\ SEGT InputLeakagoen/SEGTPin
I_OL
OutputLeakage
ICC
V,, PowerSupplyCurrent
MIN
v&I.4
-0.3
2.0
2.4
2.4
-0.3
2.4
-100
MAX Units Condition
v,,to.3
0.45
v,,to.3
v,$o.3
v,,tD.3
0.8
0.4
L-10
100
*lo
35
v Drivenby ExternaCl lockGenerator
v Drivenby ExternaCl lockGenerator
v
v
v
V
V I,,=-250uA
I”J\ b:4;‘:$ +2.4V
f#I
p4 0.4V< VIN< t2.4V
rnA 10MHz
4