Z16FMC Datasheet, PDF (15/26 Pages) Zilog, Inc. – USB Smart Cable with opto-isolator

Z16FMC™ Series Motor Control Development Kit
User Manual
9
Connector J1
Connector J1 is a 16-pin header that allows access to all Port E signals. Figure 5 displays
the pin layout. Table 3, which follows, identifies the Port E signals and their functions.
J1
PE0
PE1
12
PE2
PE3
34
56
PE4
78
PE5
9 10
PE6
PE7
11 12
13 14
15 16
HDR/PIN 2x8
Figure 5. MC MDS Board Connector JP1
Signal
PE0
PE1
PE2
PE3
PE4
PE5
PE6
PE7
GND
Table 3. Connector JP1 Signal Descriptions
Pins
1
3
5
7
9
11
13
15
2, 4, 6, 8, 10, 12, 14, 16
Direction
(with respect
to MCU)
Description
I/O
Port E[0].
I/O
Port E[1].
I/O
Port E[2].
I/O
Port E[3].
I/O
Port E[4].
I/O
Port E[5].
I/O
Port E[6].
I/O
Port E[7].
n/a
GND.
Jumper and Switch Settings
The MDS module has two SPDT switches (S2 and S3) and a 5 K potentiometer (R7) used
by the development kit’s preloaded demonstration software to perform the following func-
tions:
S2, DIRECTION. Used to change the 3-phase motor spin direction.
S3, STOP/RUN. Used to turn the 3-phase motor ON and OFF.
R7, SPEED. Used to adjust the 3-phase motor RPM.
UM023402-0811
MC MDS Module Description