ZCRMZN00100KITG Datasheet, PDF (1/8 Pages) Zilog, Inc. – One development board with no silicon installed

ZCRMZN00100KITG
Crimzon^® Development
Board Kit
PUG002601-1207
Product User Guide
Introduction
Zilog’s ZCRMZN00100KITG Crimzon^® Development Board Kit is designed for use as a
target with the Crimzon In-Circuit Emulator (ZCRMZNICE01ZEMG). The kit is powered
by two 1.5 V AAA batteries (see Figure 1). The development board can also be powered
using an adjustable DC power supply connected to input jack J13. This product user guide
helps you to install the batteries supplied with the accessory kit and tells how to verify
proper development board operation.
Kit Contents
The kit contents are listed below:
• One development board with no silicon installed
• Two 1.5 V AAA batteries
Applying Power to Development Board
Follow the steps below to apply battery power to the development board:
1. Install the two 1.5 V AAA batteries in the battery holder on the bottom of the
development board. When installing the batteries, ensure that the batteries are fully
seated in the battery holder by rotating each battery after snapping it into place.
2. Set switch SW6 (see Figure 1) to the BATTERY position.
Follow the steps below to use an adjustable DC power supply to the development board:
1. Set switch SW6 (see Figure 1) to the EXTERNAL position.
2. Connect the adjustable DC power supply to jack J13 (see Figure 1).
For more information on using the Crimzon development board accessory kit to develop
IR applications, refer to the Crimzon In-Circuit Emulator User Manual (UM0217).
Copyright ©2007 by Zilog^®, Inc. All rights reserved.
www.zilog.com