AC0603FR Datasheet, PDF (8/10 Pages) YAGEO Corporation – THICK FILM CHIP RESISTORS Automotive grade

Chip Resistor Surface Mount ^{AC SERIES 0402 to 2512}
Product specification 8
10
TEST
Solderability
- Wetting
TEST METHOD
AEC-Q200 Test 18
J-STD-002
PROCEDURE
REQUIREMENTS
Electrical Test not required Magnification 50X
SMD conditions:
(a) Method B, aging 4 hours at 155 °C dry heat,
dipping at 235±3 °C for 5±0.5 seconds.
(b) Method B, steam aging 8 hours, dipping at
215±3 °C for 5±0.5 seconds.
(c) Method D, steam aging 8 hours, dipping at
260±3 °C for 7±0.5 seconds.
Well tinned (≥95% covered)
No visible damage
Board Flex
AEC-Q200 Test 21
AEC-Q200-005
Chips mounted on a 90mm glass epoxy resin
PCB (FR4)
Bending for 0402: 5 mm
0603/0805: 3 mm
1206 and above: 2 mm
Holding time: minimum 60 seconds
±(1.0%+0.05 Ω)
<50 mΩ for Jumper
Temperature
Coefficient of
Resistance (T.C.R.)
IEC 60115-1 4.8
At +25/–55 °C and +25/+125 °C
Refer to table 2
Formula:
T.C.R= -------R---²--–--R---¹-------- ×10⁶ (ppm/°C)
R₁(t₂–t₁)
Where
t₁=+25 °C or specified room temperature
t₂=–55 °C or +125 °C test temperature
R₁=resistance at reference temperature in ohms
R₂=resistance at test temperature in ohms
Short Time
Overload
IEC60115-1 4.13
2.5 times of rated voltage or maximum
overload voltage whichever is less for 5 sec
at room temperature
±(1.0%+0.05 Ω)
<50 mΩ for Jumper
Feb 10, 2012 V.2
www.yageo.com