FR-07IK20L Datasheet, PDF (7/9 Pages) YAGEO Corporation – GENERAL PURPOSE CHIP RESISTORS

Chip Resistor Surface Mount ^{RC SERIES 0805 (RoHS Compliant)}
Product specification 7
9
TEST
Board Flex/
Bending
TEST METHOD
IEC 60068-2-21
Low
Temperature
Operation
IEC 60068-2-1
Insulation
Resistance
IEC 60115-1 4.6
Dielectric
Withstand
Voltage
IEC 60115-1 4.7
PROCEDURE
Chips mounted on a 90mm glass epoxy resin
PCB (FR4)
3 mm bending
Bending time: 60±5 seconds
REQUIREMENTS
±(1.0%+0.05 Ω) for 1%, 5% tol.
<50 mΩ for Jumper
No visible damage
The resistor shall be subjected to a DC rated
voltage for 1.5 h-on, 0.5 h-off, at -55±3 °C
This constitutes shall be repeated for 96 hours
However the applied voltage shall not exceed
the maximum operating voltage
±(0.5%+0.05 Ω) for 1% tol .
±(1.0%+0.05 Ω) for 5% tol.
No visible damage
Rated continuous overload voltage (RCOV)
for 1 minute
Type
RC0805
Voltage (DC)
100 V
≥10 GΩ
Maximum voltage (V_rms) applied for 1 minute
Type
RC0805
Voltage (AC) 300 V_rms
No breakdown or flashover
Resistance to
Solvent
IPC/JEDEC J-STD-020D
lsopropylalcohol (C₃H₇OH) followed by
brushing
No smeared
Noise
IEC 60115-1 4.12
Biased Humidity IEC 60115-1 4.37
(steady state)
Maximum voltage (Vrms) applied
Resistors range
R < 100 Ω
100 Ω ≤ R < 1 KΩ
1 KΩ ≤ R < 10 KΩ
10 KΩ ≤ R < 100 KΩ
100 KΩ ≤ R < 1 MΩ
1 MΩ ≤ R ≤ 22 MΩ
Value
10 dB
20 dB
30 dB
40 dB
46 dB
48 dB
Steady state for 1000 hours at 40 °C / 95% R.H.
RCWV applied for 1.5 hours on and
0.5 hour off
±(1.0%+0.05 Ω) for 1% tol.
±(2.0%+0.05 Ω) for 5% tol.
<100 mΩ for Jumper
Jun 16, 2009 V.4
www.yageo.com