|
1563626 Datasheet, PDF (7/9 Pages) YAGEO Corporation – GENERAL PURPOSE CHIP RESISTORS | |||
|
◁ |
Chip Resistor Surface Mount RC SERIES 0201
Product specification 7
9
TEST
Short Time
Overload
TEST METHOD
IEC60115-1 4.13
PROCEDURE
2.5 times of rated voltage or maximum overload
voltage whichever is less for 5 sec at room
temperature
REQUIREMENTS
±(1.0%+0.05 â¦)
for 1%, 0.5% tol.
±(2.0%+0.05 â¦)
for 5% tol.
<50 m⦠for Jumper
No visible damage
Board Flex/
Bending
IEC 60068-2-21
Low
Temperature
Operation
IEC 60068-2-1
Insulation
Resistance
IEC 60115-1 4.6
Dielectric
Withstand
Voltage
IEC 60115-1 4.7
Chips mounted on a 90mm glass epoxy resin
PCB (FR4)
5 mm bending
Bending time: 60±5 seconds
±(1.0%+0.05 â¦)
<50 m⦠for Jumper
No visible damage
The resistor shall be subjected to a DC rated
voltage for 1.5 h-on, 0.5 h-off, at -55±3 °C
This constitutes shall be repeated for 96 hours
However the applied voltage shall not exceed
the maximum operating voltage
±(0.5%+0.05 â¦)
for 1%, 0.5% tol.
±(1.0%+0.05 â¦)
for 5% tol.
No visible damage
Rated continuous overload voltage (RCOV)
for 1 minute
Type
RC0201
Voltage (DC)
50 V
â¥10 Gâ¦
Maximum voltage (Vrms) applied for 1 minute
Type
RC0201
Voltage (AC) 50 Vrms
No breakdown or flashover
Resistance to
Solvent
IPC/JEDEC J-STD-020D
lsopropylalcohol (C3H7OH) followed by
brushing
No smeared
Noise
IEC 60115-1 4.12
Maximum voltage (Vrms) applied
Resistors range
R < 100 â¦
100 ⦠⤠R < 1 Kâ¦
1 K⦠⤠R < 10 Kâ¦
10 K⦠⤠R < 100 Kâ¦
100 K⦠⤠R < 1 Mâ¦
1 M⦠⤠R ⤠22 Mâ¦
Value
10 dB
20 dB
30 dB
40 dB
46 dB
48 dB
May 02, 2011 V.8
www.yageo.com
|
▷ |