AC0402BRE0710R Datasheet, PDF (6/7 Pages) YAGEO Corporation – THICK FILM CHIP RESISTORS Automotive Precision grade

Chip Resistor Surface Mount ^{AC SERIES 0402 to 1206}
Product specification 6
7
TEST
Solderability
- Wetting
TEST METHOD
AEC-Q200 Test 18
J-STD-002
PROCEDURE
REQUIREMENTS
Electrical Test not required Magnification 50X
SMD conditions:
(a) Method B, aging 4 hours at 155 °C dry heat,
dipping at 235± 3 °C for 5± 0.5 seconds.
(b) Method B, steam aging 8 hours, dipping at
215± 3 °C for 5± 0.5 seconds.
(c) Method D, steam aging 8 hours, dipping at
260± 3 °C for 30± 0.5 seconds.
Well tinned (≥95% covered)
No visible damage
Board Flex
AEC-Q200 Test 21
AEC-Q200-005
Chips mounted on a 90mm glass epoxy resin
PCB (FR4)
Bending for 0402: 5 mm
0603/0805: 3 mm
1206 and above: 2 mm
Holding time: minimum 60 seconds
± (1.0%+0.05Ω)
Temperature
Coefficient of
Resistance (T.C.R.)
MIL-STD-202 Method 304
Short Time
Overload
IEC60115-1 4.13
At +25/–55 °C and +25/+125 °C
Refer to table 2
Formula:
R2 - R1
T.C.R=
× 10⁶ (ppm/°C)
R1(t2 - t1)
Where
t₁=+25 °C or specified room temperature
t₂=–55 °C or +125 °C test temperature
R₁=resistance at reference temperature in ohms
R₂=resistance at test temperature in ohms
2.5 times of rated voltage or maximum
overload voltage whichever is less for 5 sec
at room temperature
± (1.0%+0.05Ω)
FOS
ASTM-B-809-95
Sulfur (saturated vapor) 500 hours, 60± 2℃,
± ( 1.0%+0.05Ω)
unpowered
Mar. 14, 2016 V.0
www.yageo.com