CC1808KKX7REBB102 Datasheet, PDF (15/16 Pages) YAGEO Corporation – SURFACE-MOUNT CERAMIC MULTILAYER CAPACITORS

Surface-Mount Ceramic Multilayer Capacitors
High-Voltage
NP0/X7R
Product specification 15
16
1 KV to 3 KV
TEST
Endurance
TEST METHOD
IEC 60384- 4.14
21/22
PROCEDURE
REQUIREMENTS
1. Preconditioning, class 2 only:
150 +0/-10 °C /1 hour, then keep for
24 ±1 hour at room temp
2. Initial measure:
Spec: refer to initial spec C, D, IR
3. Endurance test:
Temperature: NP0/X7R: 125 °C
Specified stress voltage applied for 1,000 hours.
High-Voltage series follows the stress conditions
below:
Applied 2.0 x U_r for < 500 V series
Applied 1.3 x U_r for 500 V, 630 V series
Applied 1.2 x U_r for 1 KV, 2 KV, 3 KV series
4. Recovery time: 24 ±2 hours
5. Final measure: C, D, IR
P.S. If the capacitance value is less than the
minimum value permitted, then after the other
measurements have been made the capacitor shall
be preconditioned according to “IEC 60384 4.1”
and then the requirement shall be met.
No visual damage
∆C/C
Class1:
NP0: within ±2% or 1 pF, whichever is greater
Class2:
X7R: ±15%
D.F.
Class1:
NP0: ≤ 2 x specified value
Class2:
X7R: ≥ 25 V: ≤ 5%
R_ins
Class1:
NP0: ≥ 4,000 MΩ or
R_ins x C_r ≥ 40s whichever is less
Class2:
X7R: ≥ 1,000 MΩ or
R_ins x C_r ≥ 50s whichever is less
Voltage Proof ^{IEC 60384-1 4.6}
Specified stress voltage applied for 1 minute
U_r ≤ 100 V: series applied 2.5 U_r
100 V < U_r ≤ 200 V series applied (1.5 U_r + 100)
200 V < U_r ≤ 500 V series applied (1.3 U_r + 100)
U_r > 500 V: 1.3 U_r
I: 7.5 mA
No breakdown or flashover
Aug 08, 2011 V.4
www.yageo.com