E02 Datasheet, PDF (6/7 Pages) XP Power Limited – ISOLATED, PROPORTIONAL DC TO HV DC CONVERTERS

EXTERNAL EMI/RFI SHIELD
E SERIES – ACCESSORY
4-40 SOLDERABLE
GROUNDING STUD
2 PLACES
0.300
(7.62)
0.80
(20.32)
0.31
(7.87)
3.40
(86.36)
Ø 0.140 (3.56) THRU
2 PLACES
0.300
(7.62) _1.60
(40.64)
3.000
(76.20)
2.60
(66.04)
0.20
(5.08)
0.40
(10.16)
HIGH
VOLTAGE
0.90
(22.86)
DIMENSIONS ARE IN INCHES (METRIC EQUIVALENTS ARE IN PARENTHESIS)
DIMENSIONAL TOLERANCES: .XX = +- 0.02 (0.51), .XXX = +- 0.005 ( 0.127)
PARAMETER
BOX SIZE
MATERIAL
FINISH
MOUNTING
VALUE
See table
0.03 (0.76mm) Aluminum
Black Anodize
Two Tabs With Thru-Holes
PARAMETER
GROUND
DIMENSIONS WITH TAB
DIMENSIONS
WITHOUT TAB
VALUE
Black Anodized Aluminum
3.4L (86.36L) x 1.6W (40.64W) x 0.9H (22.86H)
2.6L (66.04L) x 1.6W (40.64W) x 0.9H (22.86H)
SHIELD DESCRIPTION
The “AB” Series provides low cost EMI/RFI shielding and rugged
mounting for XP EMCO High Voltage DC to DC converters. These
five-sided aluminum enclosures feature a durable, non-conductive
black anodized finish. The enclosures are manufactured at our own
sheet metal fabrication facility, which allows for low cost and stock
delivery. Add an “AB” suffix to the model number for a factory-installed
enclosure (e.g. E10AB). Contact our sales department by phone, fax
or email for immediate attention.
APPLICATION INFORMATION
On models with outputs of 3kV or higher, special care must be taken
to ensure adequate spacing and insulation between the metal can
and the high voltage output. Single sided layout, encapsulants or
conformal coating may be required.
Case grounding stud must be connected to ground. Case ground is
not internally connected to (-) input.
WWW.XPPOWER.COM
4719BH03
PAGE 6