DS600 Datasheet, PDF (3/11 Pages) Maxim Integrated Products – 0.5 Accurate Analog-Output Temperature Sensor

R
XA95144XL Automotive CPLD
Absolute Maximum Ratings^(1,3)
Symbol
Description
Value
Units
V_CC
V_IN
V_TS
T_STG
T_J
Supply voltage relative to GND
Input voltage relative to GND⁽²⁾
Voltage applied to 3-state output⁽²⁾
Storage temperature (ambient)⁽⁴⁾
Junction temperature
–0.5 to 4.0
V
–0.5 to 5.5
V
–0.5 to 5.5
V
–65 to +150
o_C
+125
o_C
Notes:
1. All automotive customers are required to set the Macrocell Power Setting to low, and set Logic Optimization to density.
2. Maximum DC undershoot below GND must be limited to either 0.5V or 10 mA, whichever is easier to achieve. During transitions, the
device pins may undershoot to –2.0 V or overshoot to +7.0V, provided this over- or undershoot lasts less than 10 ns and with the
forcing current being limited to 200 mA. External I/O voltage may not exceed V_CCINT by 4.0V.
3. Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress
ratings only, and functional operation of the device at these or any other conditions beyond those listed under Operating Conditions
is not implied. Exposure to Absolute Maximum Ratings conditions for extended periods of time may affect device reliability.
4. For soldering guidelines and thermal considerations, see the Device Packaging information on the Xilinx website. For Pb-free
packages, see XAPP427.
Recommended Operation Conditions
Symbol
T_A
V_CCINT
V_CCIO
V_IL
V_IH
V_O
Parameter
Ambient temperature
Supply voltage for internal logic and input buffers
Supply voltage for output drivers for 3.3V operation
Supply voltage for output drivers for 2.5V operation
Low-level input voltage
High-level input voltage
Output voltage
Min
Max
Units
–40
+85
o_C
3.0
3.6
V
3.0
3.6
V
2.3
2.7
V
0
0.80
V
2.0
5.5
V
0
V_CCIO
V
Quality and Reliability Characteristics
Symbol
T_DR
N_PE
V_ESD
Parameter
Data Retention
Program/Erase Cycles (Endurance) @ T_A = 70°
Electrostatic Discharge (ESD)
Min
20
10,000
2,000
Max
-
-
-
Units
Years
Cycles
Volts
DC Characteristic Over Recommended Operating Conditions
Symbol
V_OH
V_OL
I_IL
I_IH
Parameter
Output high voltage for 3.3V outputs
Output high voltage for 2.5V outputs
Output low voltage for 3.3V outputs
Output low voltage for 2.5V outputs
Input leakage current
I/O high-Z leakage current
Test Conditions
I_OH = –4.0 mA
I_OH = –500 μA
I_OL = 8.0 mA
I_OL = 500 μA
V_CC = Max; V_IN = GND or V_CC
V_CC = Max; V_IN = GND or V_CC
Min
2.4
90% V_CCIO
-
-
-
-
Max
-
-
0.4
0.4
±10
±10
Units
V
V
V
V
μA
μA
DS600 (v1.1) April 3, 2007
www.xilinx.com
3
Product Specification