X88064 Datasheet, PDF (9/15 Pages) Xicor Inc. – E2 Micro-Peripheral

X88064
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias.......................–65°C to +135°C
Storage Temperature ...........................–65°C to +150°C
Voltage on any Pin with
Respect to V_SS .......................................... –1V to +7V
D.C. Output Current.................................................5 mA
Lead Temperature
(Soldering, 10 seconds)300°C
RECOMMENDED OPERATING CONDITIONS
*COMMENT
Stresses above those listed under “Absolute Maximum Rat-
ings” may cause permanent damage to the device. This is a
stress rating only and the functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect device reliability.
Temperature
Commercial
Industrial
Min.
0°C
–40°C
Max.
+70°C
+85°C
Supply Voltage
X88064
X88064-60
Limits
5V ±10%
5V ±10%
7023 FRM T03
7023 FRM T04
D.C. OPERATING CHARACTERISTICS (Over recommended operating conditions unless otherwise specified.)
Symbol
Parameter
Min.
Limits
Max.
Units
Test Conditions
ICC
VCC Current (Active)
ISB1(CMOS) V_CC Current (Standby)
ISB2(TTL)
ILI
ILO
VlL(3)
VIH(3)
VOL
V_OH
VCC Current (Standby)
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Output HIGH Voltage
30
mA
CE = RD = VIL, All I/O’s = Open,
Other Inputs = VCC
150
µA
CE = VCC – 0.3V, All I/O’s = Open,
Other Inputs = VCC – 0.3V, ALE = VIL
2.5
mA
CE = VIH, All I/O’s = Open,
Other Inputs = VIH, ALE = VIL
10
µA VIN = VSS to VCC
10
µA VOUT = VSS to VCC, RD = VIH = PSEN
–1
0.8
V
2
VCC + 0.5
V
0.4
2.4
V IOL = 2.1 mA
V IOH = –400 µA
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V
Symbol
Test
Max.
Units
7023 FRM T05
Conditions
CI/O(4)
C_IN(4)
Input/Output Capacitance
Input Capacitance
10
pF
6
pF
VI/O = 0V
VIN = 0V
POWER-UP TIMING
7023 FRM T06
Symbol
Parameter
Max.
Units
tPUR(4)
tPUW(4)
Power-Up to Read
Power-Up to Write
1
ms
5
ms
7032 FRM T07
Notes: (3) V_IL min. and V_IH max. are for reference only and are not tested.
(4) This parameter is periodically sampled and not 100% tested.
9