X25041 Datasheet, PDF (8/14 Pages) Xicor Inc. – SPI Serial E2PROM with Block LockTM Protection

X25041
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias .................. –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with Respect to V_SS ......... –1V to +7V
D.C. Output Current ............................................. 5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of
the device at these or any other conditions above those
listed in the operational sections of this specification is not
implied. Exposure to absolute maximum rating condi-
tions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temp
Commercial
Industrial
Military
Min.
0°C
–40°C
–55°C
Max.
+70°C
+85°C
+125°C
6556 PGM T05
Supply Voltage
X25041
X25041-3
X25041-2.7
Limits
5V ±10%
3V to 5.5V
2.7 to 5.5V
6556 PGM T06
D.C. OPERATING CHARACTERISTICS (Over the recommended operating conditions unless otherwise specified.)
Symbol Parameter
I_CC V_CC Supply Current (Active)
Limits
Min.
Max.
3
Units
mA
I_SB
V_CC Supply Current (Standby)
150
µA
I_LI
Input Leakage Current
10
µA
I_LO
V_IL(1)
V_IH(1)
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
10
µA
–1 V_CC x 0.3 V
V_CC x 0.7 V_CC + 0.5 V
V_OL Output LOW Voltage
0.4
V
V_OH Output HIGH Voltage
V_CC–0.8
V
Test Conditions
SCK = V_CC x 0.1/V_CC x 0.9 @ 1MHz,
SO = Open
CS = V_CC, V_IN = V_SS or V_CC – 0.3V
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
I_OL = 2mA
I_OH = –1mA
6556 PGM T07.1
POWER-UP TIMING
Symbol
t_PUR(2)
t_PUW(2)
Parameter
Power-up to Read Operation
Power-up to Write Operation
Min.
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V.
Symbol
C_OUT(2)
C_IN(2)
Test
Output Capacitance (SO)
Input Capacitance (SCK, SI, CS, WP, HOLD)
Notes: (1) V_IL min. and V_IH max. are for reference only and are not tested.
(2) This parameter is periodically sampled and not 100% tested.
Max.
8
6
Max.
1
5
Units
ms
ms
6556 PGM T08
Units
pF
pF
Conditions
V_OUT = 0V
V_IN = 0V
6556 PGM T09
8