WM8959 Datasheet, PDF (32/155 Pages) Wolfson Microelectronics plc – Mobile Multimedia DAC with Dual-Mode Class AB/D Speaker Driver

WM8959
INTERNAL POWER ON RESET CIRCUIT
Pre-Production
Figure 12 Internal Power on Reset Circuit Schematic
The WM8959 includes an internal Power-On-Reset Circuit, as shown in Figure 12, which is used to
reset the digital logic into a default state after power up. The POR circuit is powered from AVDD and
monitors DCVDD. It asserts PORB low if AVDD or DCVDD is below a minimum threshold.
Figure 13 Typical Power up Sequence where AVDD is Powered before DCVDD
Figure 13 shows a typical power-up sequence where AVDD comes up first. When AVDD goes above
the minimum threshold, Vpora, there is enough voltage for the circuit to guarantee PORB is asserted
low and the chip is held in reset. In this condition, all writes to the control interface are ignored. Now
AVDD is at full supply level. Next DCVDD rises to Vpord_on and PORB is released high and all
registers are in their default state and writes to the control interface may take place.
On power down, where AVDD falls first, PORB is asserted low whenever AVDD drops below the
minimum threshold Vpora_off.
w
PP, May 2008, Rev 3.1
32