W78C438C Datasheet, PDF (8/16 Pages) Winbond – 8-BIT MICROCONTROLLER

W78C438C
The EPMA register is a nonstandard 8-bit SFR at address 0A2H in the standard W78C32. To
read/write the EPMA register, one can use the "MOV direct" instruction or "read-modify-write"
instructions. Bits <6:4> of the EPMA register are reserved bits, and their output values are 111B if
they are read. The content of EPMA is 70H after a reset. The EPMA register does not support bit-
addressable instructions.
BIT NAME
FUNCTION
7
EPMA7 EPMA7 = 0: 64 KB program/1 MB data memory space mode
EPMA7 = 1: memory-mapped chip select mode
6
EPMA6 Reserved
5
EPMA5 Reserved
4
EPMA4 Reserved
3
EPMA3 Value of AP7.3
2
EPMA2 Value of AP7.2
1
EPMA1 Value of AP7.1
0
EPMA0 Value of AP7.0
Table 1. Functional Description of EPMA Register
Additional I/O Port
The W78C438C provides one parallel I/O port, Port 8. Its function is the same as that of Port 1 in the
W78C31, except that it is mapped by the P8 register and is not bit-addressable. The P8 register is not
a standard register in the standard W78C32. Its address is at 0A6H. To read/write the P8 register, one
can use the "MOV direct" instruction or "read-modify-write" instructions.
[Example]: MOV 0A6H, A ; Output data via Port 8.
MOV A, 0A6H ; Input data via Port 8.
Additional External Interrupt
The W78C438C provides two additional external interrupts, INT2 and INT3 , whose functions are
similar to those of external interrupts 0 and 1 in the W78C32. The functions (or the status) of these
interrupts are determined by (or shown by) the bits in the XICON (External Interrupt Control) register.
For details, see Table 2. The XICON register is bit-addressable but is not a standard register in the
standard 80C32. Its address is at 0C0H. To set/clear the bit of the XICON register, one can use the
"SETB(CLR) bit" instruction. For example, "SETB 0C2H" sets the EX2 bit of XICON. The interrupt
vector addresses and the priority polling sequence within the same level are shown in Table 3.
[Example].
SETB 0C0H
; INT2 is falling-edge triggered.
SETB 0C3H
; INT2 is high-priority.
SETB 0C2H
; Enable INT2 .
CLR 0C4H
; INT3 is low-level triggered.
-8-