W78C438C Datasheet, PDF (4/16 Pages) Winbond – 8-BIT MICROCONTROLLER

W78C438C
PIN DESCRIPTION
P0.0−P0.7 I/O Port 0
These pins function the same as those in the W78C32, except that a multiplexed address/data bus is
not provided during accesses to external memory.
P1.0−P1.7 I/O Port 1
Functions are the same as in the W78C32.
P2.0−P2.7 I/O Port 2
Functions are the same as in the W78C32, except that an upper address bus is not provided during
accesses to external memory.
P3.0−P3.7 I/O Port 3
Functions are the same as in the W78C32.
DP4.0−DP4.7 Data/Address Bus
DP4 provides multiplexed low-byte address/data during access to external memory.
AP5.0−AP5.7 Address Bus
AP5 outputs the <7:0> address of the external ROM multiplexed with the <7:0> address of the
external data RAM.
AP6.0−AP6.7 Address Bus
AP6 outputs the <15:8> address of the external ROM multiplexed with the <15:8> address of the
external data RAM. During the execution of "MOVX @Ri," the output of AP6 comes from the HB
register, which is the page register for the high byte address, and its address is 0A1H.
AP7.0−AP7.3 Address Bus/Chip Select Pins
Set bit 7 of the EPMA (Extended Program Memory Address) register to determine the functions of
port 7. When this bit is "0" (default value), AP7 allows the external memory data to be accessed by
outputting the <19:16> address of the external memory from bits<3:0> of the EPMA register during
the execution of "MOVC A, @A+DPTR" or "MOVX dest, src." At all other times, AP7<3:0> will output
0H.
When this bit is "1," AP7<3:0> (CS3−0) are the chip select pins, which support memory-mapped
peripheral device select, and only one pin is active low at any one time. These pins are decoded by
AP6<7:6>. For details, see the table below.
AP6.7
0
0
1
1
AP6.6
0
1
0
1
DESCRIPTION
AP70: low; others: high
AP71: low; others: high
AP72: low; others: high
AP73: low; others: high
-4-