W25X10BL Datasheet, PDF (35/53 Pages) Winbond – 1M-BIT, 2M-BIT AND 4M-BIT 2.5V SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL I/O SPI

W25X10BL/20BL/40BL
9.2.21 Read Manufacturer / Device ID (90h)
The Read Manufacturer/Device ID instruction is an alternative to the Release from Power-down/
Device ID instruction that provides both JEDEC assigned manufacturer ID and the specific device ID.
The Read Manufacturer/Device ID instruction is very similar to the Release from Power-down / Device
ID instruction. The instruction is initiated by driving the /CS pin low and shifting the instruction code
“90h” followed by a 24-bit address (A23-A0) of 000000h. After which, the Manufacturer ID for Winbond
(EFh) and the Device ID are shifted out on the falling edge of CLK with most significant bit (MSB) first
as shown in figure 22. The Device ID values for the W25X10BL/20BL/40BL are listed in Manufacturer
and Device Identification table. If the 24-bit address is initially set to 000001h the Device ID will be read
first and then followed by the Manufacturer ID. The Manufacturer and Device IDs can be read
continuously, alternating from one to the other. The instruction is completed by driving /CS high.
31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46
Figure 22. Read Manufacturer / Device ID Diagram
- 35 -
Publication Release Date: October 14, 2009
Preliminary -- Revision A