 English |
|
|
|
|
|
|
|
| W681513_05 Datasheet, PDF (10/35 Pages) Winbond – 5V SINGLE-CHANNEL VOICEBAND CODEC FOR USB APPLICATIONS | |||
| |||
| ◁ |
W681513
can be achieved. If the transmit power amplifier is not in use, it can be powered down by connecting
PAI to VDD.
7.3. POWER MANAGEMENT
7.3.1. Analog and Digital Supply
The power supply for the analog and digital parts of the W681513 must be 5V +/- 10%. This supply
voltage is connected to the VDD pin. The VDD pin needs to be decoupled to ground through a 0.1 μF
ceramic capacitor.
7.3.2. Analog Ground Reference Voltage Output
The analog ground reference voltage is available for external reference at the VAG pin. This voltage
needs to be decoupled to VSS through a 0.01 μF ceramic capacitor.
7.4. PCM INTERFACE
The PCM interface is controlled by pins BCLKR, FSR, BCLKT & FST. The input data is received
through the PCMR pin and the output data is transmitted through the PCMT pin. The modes of
operation of the interface are shown in Table 7.3.
BCLKR
2.000 MHz
VSS
VSS
VDD
VDD
FSR
Interface Mode
8 kHz
Long or Short Frame Sync
VSS
ISDN GCI with active channel B1
VDD
ISDN GCI with active channel B2
VSS
ISDN IDL with active channel B1
VDD
ISDN IDL with active channel B2
Table 7.3 PCM Interface mode selections
7.4.1. Long Frame Sync
The Long Frame Sync or Short Frame Sync interface mode can be selected by connecting the
BCLKR or BCLKT pin to a 2.000 MHz clock and connecting the FSR or FST pin to the 8 kHz frame
sync. The device synchronizes the data word for the PCM interface and the CODEC sample rate on
the positive edge of the Frame Sync signal. It recognizes a Long Frame Sync when the FST pin is
- 10 -
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese