W3HG64M72EER-AD7 Datasheet, PDF (11/14 Pages) White Electronic Designs Corporation – 512MB - 64Mx72 DDR2 SDRAM REGISTERED, w/PLL, VLP Mini-DIMM

White Electronic Designs
W3HG64M72EER-AD7
ADVANCED
26. ODT turn-off time tAOF (MIN) is when the device starts to turn off
ODT resistance. ODT turn off time tAOF (MAX) is when the bus is in
high impedance. Both are measured from tAOFD.
27. This parameter has a two clock minimum requirement at any tCK.
28. tDELAY is calculated from tIS + tCK + tIH so that CKE registration
LOW is guaranteed prior to CK, CK# being removed in a system
RESET condition.
29. tISXR is equal to tIS and is used for CKE setup time during self
refresh exit.
30. No more than 4 bank ACTIVE commands may be issued in
a given tFAW (MIN) period. tRRRD (MIN) restriction still applies.
The tFAW (MIN) parameter applies to all 8 bank DDR2 devices,
regardless of the number of banks already open or closed.
31. tRPA timing applies when the PRECHARGE(ALL) command is
issued, regardless of the number of banks already open or closed.
If a single-bank PRECHARGE command is issued, tRP timing
applies. tRPA (MIN) applies to all 8-bank DDR2 devices.
32. Value is minimum pulse width, not the number of clock
registrations.
33. Applicable to Read cycles only. Write cycles generally require
additional time due to Write recovery time (tWR) during arto
precharge.
34. tCKE (MIN) of 3 clocks means CKE must be registered on three
consecutive positive clock edges. CKE must remain at the valid
input level the entire time it takes to achieve the 3 clocks of
registration. Thus, after any CKE transition, CKE may not transition
from its valid level during the time period of tIS + 2* tCK + tIH.
35. This parameter is not referenced to a specific voltage level, but
specified when the device output is no longer driving (tRPST) or
beginning to drive (tRPRE).
36. When DQS is used single-ended, the minimum limit is reduced by
100ps.
December 2005
Rev. 1
11
White Electronic Designs Corporation • [phone] • www.wedc.com