PS2K4 Datasheet, PDF (1/4 Pages) Wall Industries,Inc. – With PFC 2400 Watt Single Output AC/DC Switching Power Supply

PS2K4 Series
With PFC
2400 Watt Single Output
AC/DC Switching Power Supply
FEATURES
● 3 Year Warranty
● Power Good Signal
● PF > 0.98 @ 230VAC
● Case Coating with Paint
● Remote ON/OFF Control
● With Parallel Function (N+1)
● Built-in Remote Sense Option
● Forced Air Cooling by Built-in DC Fan
● AC Input Voltage 180 ~ 260VAC, 3Ø3 Wire
● AC 220VAC, 1Ø or 380VAC, 3Ø4 Wire (Option)
● Input Voltage: 90~260VAC (90 ~ 170VAC Reduced Power)
● Short Circuit/ Overload/ Over Voltage/ Over Temperature Protection
● Can Adjust from 20% ~ 100% Output Voltage by External Control 1-5VDC
SPECIFICATIONS: PS2K4 Series
All specifications are based on 25^oC, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
INPUT SPECIFICATIONS
Input Voltage Range
90 ~ 260VAC **(90 ~ 170 VAC reduced power - see “Output Power vs Input Voltage” derating curve)**
180 ~ 260VAC 3Ø3 Wire (other system available)
Input Frequency
47 to 63Hz
Input Current
13.5A / 230VAC
Inrush Current
60A / 230VAC max.
Leakage Current
3.5mA / 240VAC max.
Remote ON/OFF Control
Compatible with a TTL signal to turn ON/OFF
OUTPUT SPECIFICATIONS
Output Voltage
See Table
Output Power Range
2400 Watts max.
Voltage Adjustment Range
±5.0% typical adjustment by potentiometer
20% ~ 100% adjustment by 1-5VDC external control.
Voltage Tolerance (See Note 4)
±2.0% for PS2K4-09, ±1.0% for other models.
Line Regulation
±0.5%
Load Regulation
±1.5% for PS2K4-09, ±0.5% for other models.
Output Current
See Table
Ripple & Noise (See Note 3)
See Table
Setup, Rise, Hold-Up Time
500ms, 50ms, 16ms at full load
Temperature Coefficient
±0.04% / °C (0 ~ 50°C)
Remote Sense
Yes
PROTECTION
Over Voltage Protection
110% ~ 135% Follow to output set up point.
Protection Type: Shutdown output voltage, re-power on to recover.
Over Load Protection (See Note 5)
110% ~ 140% rated output power.
Protection Type: Current limiting, delay shutdown output voltage, re-power on to recover.
Over Temperature Protection
> 100°C / measure by heat sink, near transformer.
Protection Type: Shutdown output voltage, re-power to recover.
GENERAL SPECIFICATIONS
Efficiency
See Table
Withstand Voltage
3KVAC (input to output); 1.5KVAC (input to field ground)
Isolation Resistance
100M ohms / 500VDC (input to output, input to field ground)
Power Factor
0.98 / 230VAC
Power Good Signal
Open Collector of NPN Transistor
Special Function
DC Voltage Adjustment, Remote Sensing, Remote Control, Parallel Operation (refer to control terminal
instruction manual).
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax [phone]