LANEUW Datasheet, PDF (1/9 Pages) Wall Industries,Inc. – Single and Dual Output 2 Watt DC/DC Converter 4:1 Ultra Wide Input Range

LANEUW Series
Single and Dual Output
2 Watt DC/DC Converter
4:1 Ultra Wide Input Range
FEATURES
● Low Cost
● 1000VDC Isolation
● Efficiency up to 80%
● Low Ripple and Noise
● MTBF > 1,000,000 Hours
● Remote ON/OFF Control
● Internal SMT Construction
● 4:1 Ultra Wide Input Range
● UL 94V-0 Package Material
● Temperature Performance –40°C to +85°C
SPECIFICATIONS: LANEUW Series
All specifications are based on 25^oC, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
SPECIFICATION
TEST CONDITIONS
Min Nom Max Unit
INPUT (V_in)
Input Voltage Range (24V input models)
9
24
36 VDC
Input Voltage Range (48V input models)
18
48
75 VDC
Start Voltage 24V input models)
8
12
18 VDC
Start Voltage (48V input models)
16
24
36 VDC
Under Voltage Shutdown (24V input models)
8
VDC
Under Voltage Shutdown (48V input models)
16 VDC
Reverse Polarity Input Current
All models
0.5 A
Input Surge Voltage (1000ms) (24V input models)
-0.7
50 VDC
Input Surge Voltage (1000ms) (48V input models)
-0.7
100 VDC
Reflected Ripple Current
See Table
Short Circuit Input Power
All models
1500 mW
Input Filter
All models
Capacitor Type
OUTPUT (V_o)
Output Voltage Range
See Table
Output Voltage Accuracy
±1.0
±2.0 %
Output Voltage Balance
Dual Output, Balanced Loads
±1.0
±2.0 %
Load Regulation
Io = 25% to 100%
±0.5 ±0.75 %
Line Regulation
Vin = Min to Max
±0.3
±0.5 %
Output Power
2
W
Output Current Range
See Table
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Ripple & Noise (20MHz)
Over Line, Load, and Temperature
30
50
mV_pk-pk
75
mV_pk-pk
15 mVrms
Transient Recovery Time
25% Load Step Change
100
300 µs
Transient Response Deviation
25% Load Step Change
±3
±5 %
Temperature Coefficient
±0.01 ±0.02 %/°C
REMOTE ON/OFF
Supply On
Under 0.6VDC or Open Circuit, drops down to 0VDC by 2mV/°C
Supply Off
2.7
15 VDC
Device Standby Input Current
0.1
0.2 mA
Control Input Current (On)
-1 mA
Control Input Current (Off)
1
mA
Control Common
Referenced to Negative Input
PROTECTION
Over Power Protection
120
%
Short Circuit Protection
Continuous
Input Fuse Recommendation (24V input models)
350mA Slow-Blow Type
Input Fuse Recommendation (48V input models)
135mA Slow-Blow Type
GENERAL
Efficiency
See Table
Switching Frequency
300
KHz
Isolation Voltage Rated
60 seconds
1000
VDC
Isolation Voltage Test
Flash Tested for 1 second
1100
VDC
Isolation Resistance
500VDC
1000
MΩ
Isolation Capacitance
100KHz, 1V
250
500 pF
Maximum Capacitive Load
See Table
Internal Power Dissipation
2500 mW
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax [phone]