ILPA35JUD Datasheet, PDF (2/2 Pages) Vitec Power – 35W Dimmable Water-Proof Constant Current LED Driver

Conditions
Parameter
Test Conditions
Min.
Typ.
Operating Temperature
Humidity: 10% RH to 100% RH
-35
Storage Temperature
Humidity: 5% RH to 100% RH
-40
MTBF (Operation temperature at 25°C, calculated per MIL-HDBK-217F )
0.541M
Life Time (measured at 110VAC, 45°C ambient temperature, 80% load for 2900mA output model) 0.087M
No output power derating from -35°C to 55°C
Max.
55
85
Unit
°C
°C
Hours
Hours
Parameter
EMI
EMS
Safety UL/c-UL, CE
Waterproof
Approvals and Compliance
Standards
EN55015
EN61000-3-2, EN61000-3-3, EN61000-4-2, EN61000-4-3 , EN61000-4-4, , EN61000-4-5, EN61000-4-6,
EN61000-4-8, EN61000-4-11, EN61547
UL8750 Compliant to UL1310 Class 2, UL1012, UL935, CSA-C22.2 No. 0, CSA-C22.2 No. 107.1,
CSA-C22.2 No.250.0, EN61347-1,EN61347-2-13
IP67 Rating
Parameter
Dimension,
Net Weight
Mechanical
172x34.5x42.5mm (6.77x1.36x1.67 inches)
480g
Specification
Dimming Control
Parameter
Min.
Typ. Max.
Unit
10V Output Voltage
9.8
10V
10.2
VDC
10V Output Source Current
-10
-
2
mA
Absolute Max. Voltage on the 1~10V Input Pin
-2
-
15
VDC
Source Current on 0-10V Input Pin
0
-
1
mA
The dimmer control may be operated from either a potentiometer or from an input signal of 0 ~ 10 Vdc. Two recommended implementations are provided
above
Notes:
1. For the driver to operate properly, the load voltage must
be maintained above the minimum voltage threshold
(approx. 33% of the max. output voltage for any given
model).
2. If the input voltage is within 90-175Vac, the output current
can be varied from 100% down to 10%. (Refer to right
figure A)
3. If the input voltage is within 175-305Vac, the output
current can be varied from 100% down to 20%. (Refer to
right figure B)