TCMT110 Datasheet, PDF (2/9 Pages) Vishay Siliconix – Low temperature coefficient of CTR

www.vishay.com
TCMT110. Series
Vishay Semiconductors
ABSOLUTE MAXIMUM RATINGS (T_amb = 25 °C, unless otherwise specified)
PARAMETER
TEST CONDITION
SYMBOL
VALUE
UNIT
INPUT
Reverse voltage
Forward current
Forward surge current
Power dissipation
Junction temperature
OUTPUT
t_p ≤ 10 μs
V_R
6
V
I_F
60
mA
I_FSM
1.5
A
P_diss
100
mW
T_j
125
°C
Collector emitter voltage
Emitter collector voltage
Collector current
Collector peak current
Power dissipation
Junction temperature
COUPLER
V_CEO
70
V
V_ECO
7
V
I_C
50
mA
t_p/T = 0.5, t_p ≤ 10 ms
I_CM
100
mA
P_diss
150
mW
T_j
125
°C
AC isolation test voltage (RMS)
Related to standard climate 23/50
DIN 50014
V_ISO
3750
V_RMS
Total power dissipation
Operating ambient temperature range
Storage temperature range
Soldering temperature ⁽¹⁾
P_tot
250
mW
T_amb
- 40 to + 100
°C
T_stg
- 40 to + 125
°C
T_sld
260
°C
Notes
• Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. Functional operation of the device is not
implied at these or any other conditions in excess of those given in the operational sections of this document. Exposure to absolute
maximum ratings for extended periods of the time can adversely affect reliability.
(1) _{Refer to reflow profile for soldering conditions for surface mounted devices. Also refer to “Assembly Instructions”}
(www.vishay.com/doc?80054).
ELECTRICAL CHARACTERISTICS (T_amb = 25 °C, unless otherwise specified)
PARAMETER
TEST CONDITION
SYMBOL
MIN.
TYP.
MAX.
UNIT
INPUT
Forward voltage
Junction capacitance
OUTPUT
I_F = 50 mA
V_F
V_R = 0, f = 1 MHz
C_j
1.35
1.6
V
8
pF
Collector emitter voltage
Emitter collector voltage
Collector dark current
COUPLER
I_C = 100 μA
V_CEO
70
I_E = 100 μA
V_ECO
7
V_CE = 20 V, I_F = 0 A
I_CEO
V
V
100
nA
Collector emitter saturation voltage
Cut-off frequency
Coupling capacitance
I_F = 10 mA, I_C = 1 mA
V_CE = 5 V, I_F = 10 mA,
R_L = 100 Ω
f = 1 MHz
V_CEsat
f_c
C_k
0.3
V
100
kHz
0.3
pF
Note
• Minimum and maximum values are testing requirements. Typical values are characteristics of the device and are the result of engineering
evaluation. Typical values are for information only and are not part of the testing requirements.
Rev. 3.0, 10-Mar-16
2
Document Number: 83510
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000