TCET1600_10 Datasheet, PDF (2/8 Pages) Vishay Siliconix – Optocoupler, Phototransistor Output, AC Input

TCET1600, TCET1600G
Vishay Semiconductors ^{Optocoupler, Phototransistor Output,}
AC Input
ABSOLUTE MAXIMUM RATINGS ⁽¹⁾ (T_amb = 25 °C, unless otherwise specified)
PARAMETER
TEST CONDITION
SYMBOL
VALUE
UNIT
INPUT
Reverse voltage
V_R
6
V
Forward current
I_F
± 60
mA
Forward surge current
t_p ≤ 10 μs
I_FSM
± 1.5
A
Power dissipation
P_diss
100
mW
Junction temperature
T_j
125
°C
OUTPUT
Collector emitter voltage
V_CEO
70
V
Emitter collector voltage
V_ECO
7
V
Collector current
Collector peak current
t_p/T = 0.5, t_p ≤ 10 ms
I_C
50
mA
I_CM
100
mA
Power dissipation
P_diss
150
mW
Junction temperature
T_j
125
°C
COUPLER
Isolation test voltage (RMS)
t=1s
V_ISO
5300
V_RMS
Isolation voltage
V_IORM
890
V_P
Total power dissipation
P_tot
250
mW
Operating ambient temperature range
T_amb
- 55 to + 100
°C
Storage temperature range
T_stg
- 55 to + 150
°C
Soldering temperature ⁽²⁾
2 mm from case, t ≤ 10 s
T_sld
260
°C
Notes
(1) _{Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. Functional operation of the device is not}
implied at these or any other conditions in excess of those given in the operational sections of this document. Exposure to absolute
maximum ratings for extended periods of the time can adversely affect reliability.
(2) _{Refer to wave profile for soldering conditions for through hole devices (DIP).}
ELECTRICAL CHARACTERISTCS (T_amb = 25 °C, unless otherwise specified)
PARAMETER
TEST CONDITION
SYMBOL
MIN.
TYP.
MAX.
UNIT
INPUT
Forward voltage
I_F = ± 50 mA
V_F
1.25
1.6
V
Junction capacitance
V_R = 0 V, f = 1 MHz
C_j
50
pF
OUTPUT
Collector emitter voltage
I_C = 100 μA
V_CEO
70
V
Emitter collector voltage
I_E = 100 μA
V_ECO
7
V
Collector dark current
V_CE = 20 V, I_F = 0, E = 0
I_CEO
100
nA
COUPLER
Collector emitter saturation voltage
I_F = 10 mA, I_C = 1 mA
V_CEsat
0.3
V
Cut-off frequency
V_CE = 5 V, I_F = 10 mA,
R_L = 100 Ω
f_c
100
kHz
Coupling capacitance
f = 1 MHz
C_k
0.3
pF
Note
• Minimum and maximum values were tested requirements. Typical values are characteristics of the device and are the result of engineering
evaluations. Typical values are for information only and are not part of the testing requirements.
www.vishay.com
2
For technical questions, contact: [e-mail]
Document Number: 83538
Rev. 1.9, 10-Dec-10