English
Language : 

SI9241AEY Datasheet, PDF (2/5 Pages) Vishay Siliconix – Single-Ended Bus Transcei
Si9241AEY
Vishay Siliconix
OUTPUT TABLE AND STATE DIAGRAMS
Over Temp
Power On
A=1
Power On
B=1
Over Temp @CS
Short Circuit
CS
Note: Over Temp is an internal condition, not meant
to be a logic signal.
A=0
B=0
STATE
INPUTS VARIABLE
CS TX A
B
0
0
1
1
0
1
1
1
X
X
0
1
0
X
1
0
OUTPUT
TABLE
RX K FAULT Comments
0
0
1
1
K HiZ
K HiZ
1
1
0
Over Temp
0
Short Circuit
1
X
1
1
1
X
1
1
X = “1” or “0”
HiZ = High Impedance State
0
0
1
1
1
Receive Mode
1
ABSOLUTE MAXIMUM RATINGS
Voltage Referenced to Ground
Voltage On VBAT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −24 V to 45 V
Voltage K . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . −16 V to (VBAT + 1 V)
Voltage Difference V(VBAT, K) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 V
Voltage or Max. Current On Any Pin
(Except VBAT, K) . . . . . . . . . . . . . . . . . . . . . −0.3 V to (VDD + 0.3 V) or 10 mA
Voltage on VDD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 V
K Pin Only, Short Circuit Duration (to VBAT or GND) . . . . . . . . . . Continuous
Operating Temperature (TA) . . . . . . . . . . . . . . . . . . . . . . . . . . . . −40 to 125_C
Junction and Storage Temperature . . . . . . . . . . . . . . . . . . . . . . -55 to 150_C
Thermal Resistance QJA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 125_C/W
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation
of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device reliability.
RECOMMENDED OPERATING RANGE
Voltage Referenced to Ground
VDD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5 V to 5.5 V
VBAT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 V to 36 V
K . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 V to 36 V
Digital Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to VDD
www.vishay.com
2
Document Number: 70787
S-40137—Rev. E, 16-Feb-04