CNY17G Datasheet, PDF (2/9 Pages) Vishay Siliconix – Optocoupler, Phototransistor Output,with Base Connection

CNY17G
Vishay Semiconductors
Optocoupler, Phototransistor Output,
with Base Connection
ABSOLUTE MAXIMUM RATINGS ⁽¹⁾
PARAMETER
TEST CONDITION
SYMBOL
VALUE
UNIT
INPUT
Reverse voltage
Forward current
Forward surge current
Power dissipation
Junction temperature
OUTPUT
t_p ≤ 10 µs
V_R
5
V
I_F
60
mA
I_FSM
3
A
P_diss
100
mW
T_j
125
°C
Collector emitter voltage
Emitter collector voltage
Collector current
Collector peak current
Power dissipation
Junction temperature
COUPLER
t_p/T = 0.5, t_p ≤ 10 ms
V_CEO
32
V
V_ECO
7
V
I_C
50
mA
I_CM
100
mA
P_diss
150
mW
T_j
125
°C
Isolation test voltage (RMS)
Total power dissipation
Ambient temperature range
Storage temperature range
Soldering temperature ⁽²⁾
2 mm from case, t ≤ 10 s
V_ISO
P_tot
T_amb
T_stg
T_sld
3750
250
- 55 to + 100
- 55 to + 125
260
V_RMS
mW
°C
°C
°C
Notes
(1) _{Tamb = 25 °C, unless otherwise specified.}
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. Functional operation of the device is not
implied at these or any other conditions in excess of those given in the operational sections of this document. Exposure to absolute maximum
ratings for extended periods of the time can adversely affect reliability.
(2) _{Refer to wave profile for soldering conditions for through hole devices.}
ELECTRICAL CHARACTERISTCS
PARAMETER
INPUT
Forward voltage
Junction capacitance
OUTPUT
Collector emitter voltage
Emitter collector voltage
Collector emitter cut-off current
COUPLER
AC isolation test voltage (RMS)
Collector emitter saturation voltage
Cut-off frequency
Coupling capacitance
TEST CONDITION
I_F = 50 mA
V_R = 0 V, f = 1 MHz
I_C = 1 mA
I_E = 100 µA
V_CE = 10 V, I_F = 0
f = 50 Hz, t = 1 s
I_F = 10 mA, I_C = 1 mA
V_CE = 5 V, I_F = 10 mA,
R_L = 100 Ω
f = 1 MHz
SYMBOL
V_F
C_j
V_CEO
V_ECO
I_CEO
V_ISO
V_CEsat
f_c
C_k
MIN.
32
7
3750
TYP.
1.25
50
10
110
0.3
MAX.
1.6
100
0.3
UNIT
V
pF
V
V
nA
V_RMS
V
kHz
pF
Note
T_amb = 25 °C, unless otherwise specified.
Minimum and maximum values were tested requierements. Typical values are characteristics of the device and are the result of engineering
evaluations. Typical values are for information only and are not part of the testing requirements.
www.vishay.com
230
For technical questions, contact: [e-mail]
Document Number: 83886
Rev. 1.4, 08-May-08