HA10-2N4RM Datasheet, PDF (1/9 Pages) Vishay Siliconix – Subminiature, Leaded Solid Tantalum Capacitors Polar or Non-Polar

www.vishay.com
HA
Vishay Sprague
Subminiature, Leaded Solid Tantalum Capacitors
Polar or Non-Polar
ELECTRICAL CHARACTERISTICS
Operating Temperature Range: - 55 °C to + 125 °C
Capacitance: Measured at 120 Hz and 25 °C with a
maximum of 2.2 V_DC bias and 1.0 V_RMS signal.
Capacitance Tolerance: Standard tolerance is ± 20 % for
ratings 0.1 μF and above, and + 40 %, - 20 % for ratings
below 0.1 μF. Special tolerances are also available.
Dissipation Factor: When measured simultaneously with
capacitance, DF shall not exceed the value shown in the
ratings tables.
DC Leakage Current (DCL Max.):
When measured with DC voltage applied through a 1000 
resistor for 5 min, DC leakage (μA) shall not exceed:
At 25 °C: Leakage current shall not exceed the values listed
in the Standard Ratings tables.
At 85 °C: Leakage current shall not exceed 10 times the
values listed in the Standard Ratings tables.
At 125 °C and 66 % of rated voltage: Leakage current shall
not exceed 15 times the values listed in the Standard
Ratings tables.
Operating Voltage: Full working voltage up to 85 °C. From
85 °C to 125 °C working voltage derates linearly to 66 % of
the 85 °C working voltage.
FEATURES
• Subminiature package size and light weight
• Cylindrical case with axial or radial leads
• 2 V_DC to 50 V_DC
• 0.001 μF to 68 μF
• Operating temperature range: - 55 °C to + 125 °C
• High stability and reliability
• Tested in accordance with MIL-PRF-49137
• Unique and comprehensive custom design capability
APPLICATIONS
• Hearing aids
• Portable communications
• Space/avionics
• Laptop computers
MECHANICAL SPECIFICATIONS
Solder coated nickel leads (type N32 per MIL-STD-1276) are
standard on all case sizes.
Leads are weldable and/or solderable.
Special leads are available on request (e.g. bare nickle, gold
plated nickle or ribbon leads).
Lead length is 1 1/2" [38.1 mm] minimum on non-polar parts.
On polar parts the negative lead is 1 1/4" [31.8 mm]
minimum and the positive lead is 1 1/2" [38.1 mm] minimum.
ORDERING INFORMATION
HA
1.0
35
MODEL CAPACITANCE DC VOLTAGE RATING
IN μF
AT + 85 °C
Example of Part Number Code: HA1.0-35C7AM
C7
CASE CODE
C = Polar
N = Non-polar
A ⁽¹⁾
LEAD CONFIGURATION
A = Axial
R = Radial
M
CAPACITANCE TOLERANCE
E = + 40 %, - 20 %
M = ± 20 %
K = ± 10 %
J=±5%
Note
(1) _{To complete part number in rating tables, add A or R.}
Change suffix if special capacitance tolerance is required.
Revision: 05-Dec-07
1
Document Number: 43003
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000