PRD48AF480T400A00 Datasheet, PDF (4/9 Pages) Vicor Corporation – PRM-AL Customer Evaluation Boards

Recommended Hardware
Qty
Description
4
Ring lug
Manufacturer P/N
Panduit LCAS6-10-L
Kit # 26647 contains:
Qty
Description
4
#10-32 screw
4
#10 flat washer
4
#10 lock washer
4
#10 hex nut
All hardware is stainless steel except the ring lug.
Kit # 26647 is included with the Customer Evaluation Board.
Initial Set Up
To test the PRM® mounted to the board it is necessary to configure the switch bank
(Item 5) as shown on the silk screen in Figure 3. Placing the switch bank in this state
connects a fixed resistor between OS and SG of the PRM that sets the output voltage of
the PRM to the nominal value indicated on its respective data sheet.
Failure to configure the switch bank in this state prior to testing may result in
improper output or no output.
Baseline Test Procedure - PRM-CB (Refer to Figure 3)
1.0 Recommended Equipment
1.1 DC power supply – 0-100 V; 500 W
1.2 DC electronic load – pulse capable; 0-100 V; 100 A minimum
1.3 DMM
1.4 Oscilloscope
1.5 Appropriately sized interconnect cables
1.6 Fastening hardware
1.7 Fan (if the PRM is to be operated for extended periods of time or at an elevated
ambient temperature we recommend the supplied heat sink be installed)
1.8 Safety glasses
1.9 Data sheet for the requisite PRM
UG:003
vicorpower.com
Applications Engineering: 800 927.9474
Page 4