PI33XX Datasheet, PDF (4/42 Pages) Vicor Corporation – 8V to 36Vin Cool-Power ZVS B uck Regulator Family

PI33XX-X0
Pin Description
Name
SGND
PGND
VIN
VOUT
VS1
PGD
EAO
EN
REM
ADJ
Number
Block 1
Block 2
Block 3
Block 5
Block 4
A1
A2
A3
A5
B1
TRK
NC
SYNCO
C1
K3, A4
K4
SYNCI
K5
SDA
D1
SCL
E1
ADR1
H1
ADR0
G1
Description
Signal ground: Internal logic ground for EA, TRK, SYNCI, SYNCO, ADJ and I²C (options)
communication returns. SGND and PGND are star connected within the regulator package.
Power ground: VIN and VOUT power returns
Input voltage: and sense for UVLO, OVLO and feed forward ramp
Output voltage: and sense for power switches and feed-forward ramp
Switching node: and ZVS sense for power switches
Parallel Good: Used for parallel timing management intended for lead regulator.
Error amp output: External connection for additional compensation and current sharing.
Enable Input: Regulator enable control. Asserted high or left floating – regulator enabled;
Asserted low, regulator output disabled. Polarity is programmable via I²C interface.
Remote Sense: High side connection. Connect to output regulation point.
Adjust input: An external resistor may be connected between ADJ pin and SGND or VOUT to trim
the output voltage up or down.
Soft-start and track input: An external capacitor may be connected between TRK pin and SGND
to decrease the rate of rise during soft-start.
No Connect: Leave pins floating.
Synchronization output: Outputs a low signal for ½ of the minimum period for synchronization of
other converters.
Synchronization input: Synchronize to the falling edge of external clock frequency. SYNCI is a high
impedance digital input node and should always be connected to SGND when not in use.
Data Line: Connect to SGND for PI33XX-10 and -11. For use with PI33XX-20 and -21 only.
Clock Line: Connect to SGND for PI33XX-10 and -11. For use with PI33XX-20 and -21 only.
Tri-state Address : No connect for PI33XX-10 and -11. For use with PI33XX-20 and -21 only.
Tri-state Address : No connect for PI33XX-10 and -11. For use with PI33XX-20 and -21 only.
Package Pin-Out
PGND
Block 2
1 2 3 4 5 6 7 8 9 10 11 12 13 14
SGND ^K
Block 1
J
ADR1 H
VIN
Block 3
ADR0 G
SGND F
SCL E
SDA D
TRK C
ADJ B
VS1
Block 4
PGD A
VOUT
Block 5
123-Lead LGA (10mm x 14mm)
Top view
Block 1: B2-4, C2-4, D2-3, E2-3, F1-3, G2-3,
H2-3, J1-3, K1-2
Block 2: A8-10, B8-10, C8-10, D8-10, E4-10,
F4-10, G4-10, H4-10, J4-10, K6-10
Block 3: G12-14, H12-14, J12-14, K12-14
Block 4: A12-14, B12-14, C12-14, D12-14,
E12-14,
Block 5: A6-7, B6-7, C6-7, D6-7
vicorpower.com
800 735.6200
Rev 1.4
11/2012
Cool-Power^®
Page 4 of 42