V150C12C150BL_15 Datasheet, PDF (3/11 Pages) Vicor Corporation – DC-DC Converter Module

MODULE FAMILY ELECTRICAL CHARACTERISTICS (CONT.)
150 V Input
MODULE CONTROL SPECIFICATIONS
Parameter
Min
Typ
PRIMARY SIDE (PC = Primary Control; PR = Parallel)
PC bias voltage
current limit
5.50
5.75
1.5
2.1
PC module disable
2.3
2.6
PC module enable delay
4
PC module alarm
PC resistance
0.9
1.0
PR emitter amplitude
5.7
5.9
PR emitter current
150
PR receiver impedance
375
500
PR receiver threshold
2.4
2.5
PR drive capability
SECONDARY SIDE (SC = Secondary Control)
SC bandgap voltage
1.21
SC resistance
990
SC capacitance
SC module alarm
1.23
1000
0.033
0
Max
Unit
6.00
Vdc
3.0
mA
2.9
Vdc
7
ms
0.5
Vavg
1.1
MΩ
6.1
Volts
mA
625
Ω
2.6
Volts
12
modules
1.25
Vdc
1010
Ω
µF
Vdc
Notes
PC current = 1.0 mA
PC voltage = 5.5 V
Switch must be able to sink ≥4 mA. See Fig. 2
UV, OV, OT, module fault. See Figs. 3 and 5
See Fig. 3, converter off or fault mode
PR load >30 Ω, < 30 pF
25°C
Minimum pulse width: 20 ns
Without PR buffer amplifier
Referenced to –Sense
With open trim; referenced to –Sense. See Fig. 7
MODULE GENERAL SPECIFICATIONS
Parameter
Min
Isolation test voltage (in to out)*
Isolation test voltage (in to base)*
Isolation test voltage (out to base)*
Isolation resistance
3000
1500
500
Weight (E, C, T grade)
1.9
(52.8)
Weight (H, M grade)
2.1
(58.7)
Temperature limiting
100
Typ
10
2.1
(59.3)
2.3
(65.2)
115
Max
2.3
(65.8)
2.5
(71.7)
Agency approvals
cURus, cTÜVus, CE
Unit
Vrms
Vrms
Vrms
MΩ
ounces
(grams)
ounces
(grams)
°C
* Isolation test voltage, 1 minute or less.
Note:
Specifications are subject to change without notice.
Notes
Complies with reinforced insulation requirements
Complies with basic insulation requirements
Complies with operational insulation requirements
in to out, in to baseplate, out to baseplate
See Figs. 3 and 5. Do not operate coverter >100C.
UL60950-1, EN60950-1, CSA60950-1, IEC60950-1.
With appropriate fuse in series with the +Input
150 V Micro Family
Page 3 of 11
Rev 2.8
09/2015
vicorpower.com
800 927.9474