PI2002 Datasheet, PDF (19/23 Pages) Vicor Corporation – Active ORing Controller IC with Load Disconnect Feature

5. OCT pin: Connect 18nF capacitor between OCT
pin and the GND pin to achieve the maximum off
time after forward over-current condition occurs.
6. SCD pin: Connect the SCD pin to the VC pin
for slow MOSFET turn on to avoid over-current
shutdown due to inrush current.
7. FT pin: Connect the FT pin to logic input and
to the logic power supply or to the VC pin via a
resistor.
UV and OV inputs: UV and OV are not used in this
example. Connect UV pin to VC pin and OV pin to
GND pin do not leave them unconnected.
Figure 22: PI2002 (10L-TDFN package) in low side
disconnect switch application
Picor Corporation • picorpower.com
PI2002
Rev1.1 Page 19 of 23