BCM384P120T800AC1 Datasheet, PDF (17/23 Pages) Vicor Corporation – Fixed Ratio DC-DC Converter

System Diagram
BCM384y120x800AC1
-OUT
BCM
Digital Isolator
I13TL1A0
BCM EN
SER-IN
SER-OUT
-IN BCM
PRI-OUT-A
PRI-OUT-B
PRI-IN-C
PRI-COM
SEC-IN-A
SEC-IN-B ^TXD1’
RXD1
SEC-OUT-C
SEC-COM
SCL
5V EXT
RXD4
VDDB
RXD3
VDD
RXD2 ^Digital NC
RXD1 Supervisor _NC
VDD ^TXD4 _D44TL1A0 ^NC
TXD3
SSTOP
10 kΩ
3 kΩ
3 kΩ
VDD
CP
VCC
D
D
SD
Q _Flip-flop RD
SGND
Q
74LVC1G74DC
10 kΩ
FDG6318P
SGND
R1
R2
EN Control
3.3V, at least 20mA
when using 4xDISO
Ref to Digital Isolator
datasheet for more details
SDA Host
SCL
μc
PMBus
The BCM384y120x800AC1 bus converter provides accurate telemetry monitoring and reporting, threshold and warning limits
adjustment, in addition to corresponding status flags.
The BCM internal µC is referenced to primary ground. The Digital Isolator allows UART communication interface with the host Digital
Supervisor at typical speed of 750 KHz across the isolation barrier. One of the advantages of the Digital Isolator is its low power
consumption. Each transmission channel is able to draw its internal bias circuitry directly from the input signal being transmitted to
the output with minimal to no signal distortion.
The Digital Supervisor provides the host system µC with access to an array of up to 4 BCMs. This array is constantly polled for status
by the Digital Supervisor. Direct communication to individual BCM is enabled by a page command. For example, the page (0x00) prior
to a telemetry inquiry points to the Digital Supervisor data and pages (0x01 – 0x04) prior to a telemetry inquiry points to the array of
BCMs connected data. The Digital Supervisor constantly polls the BCM data through the UART interface.
The Digital Supervisor enables the PMBus^TM compatible host interface with an operating bus speed of up to 400 kHz. The Digital
Supervisor follows the PMBus command structure and specification.
Please refer to the Digital Supervisor data sheet for more details.
BCM^® Bus Converter
Page 17 of 23
Rev 1.2
05/2015
vicorpower.com
800 927.9474