V110B24C200BL_16 Datasheet, PDF (12/14 Pages) Vicor Corporation – DC-DC Converter Module

Parallel Bus Output
Module 1
+OUT
+S
SC
–S
–OUT
Module 2
+OUT
+S
SC
–S
–OUT
+OUT
+S
Module N+1 SC
–S
–OUT
+S
Load
–S
Figure 11 — N+1 module array output connections
110V Input
• The +Out and –Out power buses should be designed to
minimize and balance parasitic impedance from each
module output to the load.
• The +Sense pins must be tied together to form a
+Sense bus. This must be Kelvin connected to +Out at a
single point. The –Sense pins should be tied together to
form a –Sense bus. This must be Kelvin connected to –Out
at a single point.
• At the discretion of the power system designer, a subset
of all modules within an array may be configured as slaves
by connecting SC to –S.
• OR’ing diodes may be inserted in series with the +Out pins
of each module to provide module output fault tolerance.
• The +Sense and -Sense leads should be routed in close
proximity to each other on the printed circuit board. If wires
are used to connect the converters on a PCB to an external
load, the Sense leads should be twisted together to reduce
noise pickup.
PIN STYLES*
Designator
Description
Finish
(None)
Short
Tin/Lead
L
Long
Tin/Lead
S
Short ModuMate
Gold
N
Long ModuMate
Gold
F
Short RoHS
Gold
G
Long RoHS
Gold
K
Extra Long RoHS
Gold

Notes
Requires in-board, mounting
On-board mounting for 0.065” boards
SurfMate or in-board socket mounting
On-board socket mounting
Select for RoHS compliant in-board solder, socket, or SurfMate mounting
Select for RoHS compliant on-board solder or socket mounting
Select for RoHS compliance on-board mounting for thicker PCBs
(not intended for socket or Surfmate mounting
* Pin style designator follows the “B” after the output power and precedes the baseplate designator.
Ex. V110B12T200BN2 — Long ModuMate Pins
110V Mini Family
Page 12 of 14
Rev 3.4
10/2016
vicorpower.com
800 927.9474