VS700_09 Datasheet, PDF (3/7 Pages) Vectron International, Inc – Voltage Controlled SAW Oscillator

Parameter
Power Supply
Input Current
Output Current
Voltage Control Range
Storage Temperature
Soldering Temperature / Duration
Absolute Maximum Ratings
Symbol
V
CC
I
IN
I
OUT
V
C
T_STR
T /t
PEAK P
Ratings
0 to 6
100
25
0 to V
CC
-55 to 125
260 / 40
Unit
V
mA
mA
V
°C
°C / sec
Stresses in excess of the absolute maximum ratings can permanently damage the device. Also, exposure to these absolute
maximum ratings for extended periods may adversely affect device reliability. Functional operation is not implied at these or any
other conditions in excess of those represented in the operational sections of this datasheet. Permanent damage is also possible if
any device input (Vc or OD) draws >100 mA.
Suggested Output Load Configuration
LV-PECL to LV-PECL: For short transmission lengths, the power
consumption could be reduced by removing the 100Ω resistor and
doubling the value of the pull down resistors.
LV-PECL to LVDS: Restricted for short transmission lengths.
Configuration may require modification depending on LVDS receiver.
Functional Test: Allows standard power supply configuration.
Since AC coupled, the LV-PECL levels cannot be measured.
Production Test: Allows direct DC coupling into 50Ω measurement
equipment. Must bias the power supplys as shown. Similiar to figure 1.
Page3 of 7
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • http://www.vectron.com
Rev: 08Dec2009